# Leather bookmark

# Introduction

This is just a simple bookmark.

I did not record all the steps, however this is just a simple piece of carved leather with a hole in it, nothing very complex to reproduce.

The length is 16cm, width is 3.5cm, and thickness 2.5mm.

# Step by Step

General viking knot pattern:

![](/assets/images/marque_page/000_big.jpg)

Next, add the hole (4mm diameter, but this depends on your drawing)

![](/assets/images/marque_page/003_big.jpg)

Zoom on the carved pattern.

![](/assets/images/marque_page/004_big.jpg)

Dying:

- brown: Eco-flo  Watershtein light brown,
- Eco-flo supershene on knot pattern
- Black acrylic inside the knot pattern
- Eco-flo Antic finish han
- Fiebing black edge kote


![](/assets/images/marque_page/009_big.jpg)

Edges:

- Before

![](/assets/images/marque_page/011_big.jpg)

- After


![](/assets/images/marque_page/012_big.jpg)


Final result:

![](/assets/images/marque_page/014_big.jpg)
![](/assets/images/marque_page/015_big.jpg)

Burnished back: as for edge burnishing, but for a plane surface. It gives a very nice finish, as for the top (very smooth touch).

![](/assets/images/marque_page/016_big.jpg)
![](/assets/images/marque_page/017_big.jpg)