For this project, I needed to plywood sheet of 40x80 cm with 3.7 mm thickness (do not ask me why my vendor do 3.7mm plywood …).
TODO: inspiration ??
I started with the main structure.
I glued horizontal part first, used a good dictionary to get everything clamped correctly.
When my laser playground was too small to cut large pieces, I did some assembly.
After the four structural parts are done, I glued them together. We need to pay attention to squareness !
While the structure is drying, I cutted the drawers part. I saved some wood on the back side (not visible from the outside).
All drawers are identical, only the face has a different number.
With the first batch of drawers, test if they correctly fit in the structure.
Print all the faces in a same batch on the same wood, so the lines goes into the same direction.
>> You can subscribe to my mailing list here for a monthly update. <<