This is just a simple bookmark.
I did not record all the steps, however this is just a simple piece of carved leather with a hole in it, nothing very complex to reproduce.
The length is 16cm, width is 3.5cm, and thickness 2.5mm.
General viking knot pattern:
Next, add the hole (4mm diameter, but this depends on your drawing)
Zoom on the carved pattern.
Dying:
Edges:
Final result:
Burnished back: as for edge burnishing, but for a plane surface. It gives a very nice finish, as for the top (very smooth touch).
>> You can subscribe to my mailing list here for a monthly update. <<